This means that this car seat will serve you from infancy until the day your child won’t need a car seat anymore. After the size limits, the installation comes. This is important because there are so many seats installed wrong.
The Extend2Fit can remain rear-facing up to 50 lbs, making it relatively unique, and it sports a no-rethread harness height adjustment you can operate with your baby in the seat. This Graco is almost 19 inches wide, which makes it a challenge to fit three safety seats across or two seats and an adult. It can be slightly harder to install, and the quality isn’t as nice as similarly priced options. However, this seat has the best crash test results, a budget-friendly price, and children can remain rear-facing longer . So if you want the best crash test results, then this Graco could be the one for you. Well these convertible car seats are quite similar.
Check the Buckle Position The correct slot is the one that is closest to your child without being underneath them. Tighten the Vehicle Seat Belt Press down firmly in the center of the car seat. Pull on the shoulder belt to tighten while feeding the slack back in the retractor. Page 15According to the AAP , these infants may suffer breathing issues if improperly reclined in a car seat. When rear-facing, use the corrected age for preemies.
It’s a nice feature, but like other similar designs, we think most parents will stop using it after a few months. While this Graco did not earn the top results for the head sensor or the chest clip sensor , it did have the best-combined sensor results for the group. The Graco is definitely one of these seats. The Graco company started in 1953 after Graco Metal Products decided to shift gears by hiring an engineer to design new types of products.
Recline position #4 is required when the seat is installed forward-facing for a child weighing less than 40 lbs. Page 88Grab hold of the shoulder straps and pull them out of their slots on the seat pad. From the back of the seat, undo the elastic straps. Undo both elastic straps from the sides of the seat. Place Car Seat Rear-Facing in Back Seat of the Vehicle Place rear-facing in vehicle seat.
They both allow the latch and seat belt install. My issue with the latch system was that its first generation. So many years have passed, and they graco extend to fit haven’t upgraded it. If you want to get better at installing the car seat, you need to practice. If you have done it a dozen times, it’s enough.
Turn the metal retainer on its side and hold it tight while pulling the buckle from the top of the seat. It should slip through the slot, though you may have to push it up too. Then push it down through the the outside slot in the fabric and the carseat shell. Lift up to make sure the retainer is secure beneath the seat shell. Push the extension panel all the way back and you’re done. As always with any forward-facing installation, don’t forget to use the top tether regardless of whether you install the Extend2Fit using the seat belt or lower LATCH strap.