Your model determines how to remove the seat pad. Follow the instructions that match your seat. Seat Pad Raise the headrest all the way up. Attach Top Tether Strap Extend the top tether by lifting up on the tether lock and attach. Consult vehicle’s owner manual for specific location. Page 333-B Installing Rear-Facing With LATCH Straps Review your vehicle’s owner manual for LATCH location and use.
There are also 6 different recline positions that, again, are very easy to adjust. Have you ever installed a car seat only to realize you forgot to adjust the recline, consequently, you had to uninstall the whole thing and start all over again? With the Graco 4Ever Extend2Fit 4-in-1 car seat, you won’t need to do that because graco duo glider you can adjust the recline of the seat from either the front or the back of the seat. The Extend2Fit has three recline positions for rear-facing, which you can adjust using the grey handle on the base. Which position you need to use to get the ball within the correct range will depend on the slope of your vehicle seat.
Because this seat is 19 inches wide, you would not be able to fit 3 seats across a vehicle. However, this is only going to pose a problem for families with a few young children. One of the things I was concerned about with this seat was how hard it would be to remove the harness straps once the seat was adjusted for use as a booster. Thankfully, Graco integrated a harness storage compartment, which holds unused harness straps while in the belt positioning booster mode.
High weight and height limit may allow a child to ride safely longer in rear-facing mode, which doesn’t require use of the top tether . For the vast majority of vehicles, the Extend2Fit will be a good fit thanks to the flexibility offered by the three possible forward-facing reclines. In the case of very short vehicle seat pans or forward-leaning, non-removable headrests, it’s always wise to test the install before you buy. Remember that at a child weight of 45 lb, you must install the Extend2Fit with the vehicle seat belt. However, it’s a bit finicky to reattach the seat cover. Both the lower anchor and the seat belt installation in rear-facing mode are straightforward and user-friendly.
A weird safety issue one parent discovered involved the warning labels on the cushions. Apparently, they are screen-printed on and can get really hot. So you may want to feel them first in hot weather to make sure it won’t be a burn hazard.
The LATCH anchors attach to the underside lip of the Graco shell on either side . This storage design keeps the anchors out of the way but also leaves them exposed for possible play by little ones. The manual stores on the base under the seat where it is easy to access but out of the way of spills and potential vomit. The Extend2Fit has a tightening strap on the foot and a harness release button hidden under the fabric and out of the sight of little ones. The belt path for the Extend2Fit forward-facing configuration is harder to use because you can’t see what is going on. Removing the cover for visibility is also challenging.
In the secondary features, the Graco Extend2fit won a point again because it has more options than the Milestone. The fabric is easy to wash because it’s washing machine friendly. The best advice is to use cold water and a gentle cycle. I’ve managed to find a single difference between the two. With the Graco Extend2fit, you will have a much easier time removing it than the Milestone.
When installing with the seat belt, the belt path is wide, and it is easy to feed the seat belt through. Pull the chest clip all the way down and pull the slack from the straps. Then tighten and push the chest clip back up to armpit level.
(And for my generation, our parents may have had us facing the front even earlier!) My son was born in 2012, and I was getting grief for him still being rear-facing at 18 months. The 10-position headrest adjusts easily for your growing child. How do you know what recline position to use rear facing? One of the biggest complaints some parents had involved removing and replacing the cover when washing it.
The pale blue circle is where the little silver ball must sit for babies aged 0–3 months so that the seat is adequately reclined for a newborn. There is then the dark blue range which is acceptable for older babies, toddlers and preschoolers depending on their comfort and the graco extend to fit fit to vehicle. The foot panel had to be extended to position 3 for a child weighing over 22 lb , and the extended foot panel significantly increased the front-to-back space occupied by the seat. Therefore, you may have heard that the seat was too large for compact vehicles.